Server Board Connector and Component Locations
2
MAXDATA PLATINUM 500 I M8 – Quick Start Guide
A.
Slot 2, PCI 32 bit/33 MHz
S.
Jumper (not in use)
AK.
SATA port 3
B.
Slot 3, PCIe Gen II x4
T.
TPM header
AL.
SATA port 4
C.
Slot 4, PCIe Gen III x8
U.
LCP header
AM.
SATA port 5
D.
RMM 4 LITE
V.
System fan 6 header
AN.
SATA port 0
E.
Slot 5, PCIe Gen III x8, open-ended
W.
HSBP I2C header
AO.
SATA port 1
F.
Slot 6, PCIe Gen III x16
X.
System fan 5 header
AP.
SCU 1
G.
DIMM sockets of CPU 2 (channels D, E, F)
Y.
System fan 4 header
AQ.
eUSB SSD header
H.
Diagnostic LEDs
Z.
ME update jumper
AR.
RAID upgrade key
I.
CPU 2 fan header
AA.
System fan 3 header
AS.
SCU 0
J.
USB and network connectors
AB.
System fan 2 header
AT.
Password clear jumper
K.
Video port
AC.
SATA SGPIO
AU.
BIOS recovery jumper
L.
Serial port A
AD.
System fan 1 header
AV.
BMC update jumper
M.
CPU 2 power
AE.
PMBus header
AW.
RMM 4 header
N.
System fan 7 header
AF.
HDD LED header
AX.
Front panel header
O.
DIMM sockets of CPU 1 (channels A, B, C)
AG.
Type A USB port
AY.
USB header
P.
CPU 1 power
AH.
IPMB header
AZ.
Serial port B header
Q.
CPU 1 fan header
AI.
Main power
R.
BIOS default jumper
AJ.
SATA port 2
Hard Disk Drive Numbering
The HDDs of each 4x backplane are numbered from bottom to top in ascending order.
If two backplanes are in use and both are connected to the same controller, the lower four drive
bays are connected to ports 0 to 3, while the upper four drive bays are connected to ports 4 to 7.
Per default, the HDDs numbers and positions are as follows:
The HDDs of each 8x backplane are numbered from top to bottom in ascending order.
3.5" hot-swap HDDs
2.5" hot-swap HDDs
CMOS
battery
CPU 2
CPU 1
