CONTENTS
www.maxcessintl.com
DLCA NET-S1
MI 850A374 1 A
Page 8 of 67
Product overview continued
The DLCA NET-S1 has three alarm outputs. Two of the alarm
outputs can be configured to sense tension limits on either of
the two sensor inputs. The third alarm output is on when there
are no load cell wiring problems detected or power faults. This
is essentially a 'power good' indicator.
The DLCA NET-S1 has four analog outputs that represent
tension; see Section 3.4.
The DLCA NET-S1 has two digital inputs that allow remote
zeroing of the tension reading in each tension zone. There is
also a front panel "zero" button [
n
], which allows zeroing of
the tension zone currently being displayed.
Load cell diagnostics run during power-up and provide
information about load cell wiring problems.
The DLCA NET-S1 has a web server interface to allow
configuration and calibration from a web browser.
1.2.1
Additional tools
Two software tools can be downloaded and installed for use
with the DLCA NET-S1:
The DLCA NET Data Logger software provides an easy way to
record tension data on your computer without complicated
programming.
The Terminal Tool software backs up your DLCA NET-S1
settings, which you can then upload after a reset or
replacement.
The manuals for these tools are available at
www.maxcessintl.com.
