www.maxairrc.com
Page 9 of 19
Fuselage Assembly
Step 5 – Prepare the servo cutouts
The first step in assembling the fuselage is to
prepare the servo cutouts. The MAXAIR Velox
RII was designed to allow for multiple servo
configurations. Pull-pull hardware is included
with the kit, but if required, the rudder servo can
be installed in the tail.
a. Cut the covering off of the left side
elevator servo cutout. Don’t forget to
leave a 3mm (1/8) wide strip around the
inside of the cutout that you will iron
down to the sides of the cutouts.
The cutout can be found using the
dimension in the image below.
Left side elevator servo cutout location
b. Repeat with the right side servo cutout
using the dimensions in the image
below.
Right side elevator servo cutout location
If you opt to put the rudder servo in the tail, the
rudder servo cutout can be found on the left side
of the fuselage below and behind the elevator
servo cutout as seen in the picture below.
The pull-pull wire exit is also shown in the picture
below.
Elev., rudder and pull-pull cutouts
Do not remove covering from all servo cutouts
and exit holes. Only remove the covering from the
servo cutouts and exit holes required.
