P/N 01023649 Rev B Page 2
DLC Cuffs
(Disposable Lens Cuffs)
User Instructions
WARNING
Always start with the ML size unless the wearer has a very small head size.
The DLC Cuff side must face to the inside of the Helmet; the Lens side must face to the outside of the Helmet.
NOTE
This shows the 2081-03 Helmet with 2061-08 FCC; it is similar for the 2083-03 Helmet and 2061-04A Hard Hat.
Assembly
1. Secure the Helmet/FCC in your
lap with the Helmet front facing
up, and the top of the Helmet
facing in towards you.
4. With thumbs pressing the DLC
against the FCC front white
foam strip, press and slide your
thumbs down each DLC side
until you can grasp each end of
the DLC at the Flappers.
3. Ensure the DLC Front
alignment hole is
centered on the Front
Turn Clip.
2. Align the FCC front TurnClip horizontally,
snap the DLC Front Alignment Hole over
the TurnClip, then position the TurnClip
vertically to lock the DLC in place.
5. Pull each DLC side down
towards the Helmet back and
tightly against the white foam
strip, position each side DLC
Mounting Hole as centered as
possible over each respective
FCC side Mounting Post.
6. Press the DLC tightly against the
FCC to secure the Mounting Hole
onto each Mounting post. (You
will hear an audible “click” when
properly secured).
Assembly Steps 4-6 Option A
