Maxair 2099-14 User Instructions Download Page 3

Page: 3 / 4

Page 3 P/N 01023672 Rev C

User Instructions

2099-14 Adapters

Hard Hat

Remove a Side Lens Mount (Same for both sides of HH)

Assemble a Side Lens Mount (Same for both sides of HH)

Alternative to step 2, position both thumbs at

bottom edge of HH Skirt for support, and use the

screwdriver flat blade on top of the protruding

post and press down to remove the Lens Mount.

1. Grasp a Side Lens Mount between thumb and

forefinger and slide it into the Lens Mount slot

in the HH.

2. Press the Side Lens Mount fully up into the slot as shown in A.

Alternatively, use the Screwdriver Flat Blade as leverage to push the Lens Mount

fully into the Lens Mount Slot.

1. Locate a Side Lens Mount

2. Grasp the Side Lens Mount between thumb and

forefinger and pull down and away from the HH.

Summary of Contents for 2099-14

Page 1: ...ment relative to regulatory requirements Bio Medical Devices Intl Inc does not recommend the appropriate systems for a particular institution or facility Use only MAXAIR Systems NIOSH approved compati...

Page 2: ...driver inward with controlled force to push the Front Lens Mount out of the HH 1 From inside the HH place a new Front Lens Mount into the front hole on the HH 2 Position the Front Lens Mount as shown...

Page 3: ...flat blade on top of the protruding post and press down to remove the Lens Mount 1 Grasp a Side Lens Mount between thumb and forefinger and slide it into the Lens Mount slot in the HH 2 Press the Side...

Page 4: ...ade through the Side Turn Clip Base 5 Bracing the the HH from the inside push the screwdriver inward with controlled force to push the Side Turn Clip Base out of the HH 1 From inside the HH place a ne...