20
13.WARNING BUZZERS AND PROCEDURES TO FOLLOW
This tool sounds warning buzzers for the conditions described below. If the buzzer sounds, follow
procedures according to the conditions described below.
<Buzzer types and procedures to follow>
• If the conditions described below occur, set the Main switch (Fig.1.
e
) at "OFF" and remove
the Battery pack (Fig.1.
5
) before following procedures.
• Do not touch the tying or rotating parts at the tip when setting the Main switch at "ON" under
any circumstances.
Buzzer types
Possible cause
Procedures to follow
Once (Pi, pi, pi...)
Wire is jammed in the Hook
(Fig.1.
f
)
Check whether the wire or anything else
is caught in the Hook
Motor is hot
Let the tool rest and cool down
Main switch is set at "ON" with the
Contact switch pressed.
Set the Main switch at "ON" without the
Contact switch being pressed.
Twice (Pipi, pipi, pipi...)
Low battery
Charge the Battery pack
Battery pack is not fully inserted
Insert the Battery pack properly
Three times (Pipipi,
pipipi, pipipi...)
Tiewire is used up
Replace with a new Tiewire
Tiewire is jammed
Open the Magazine cover (Fig.10.
n
)
and fix the jammed wire
Dust the sensor in Magazine.
Dust the sides of sensors and lenses
with water or cotton bud gently.
Continuous high pitched
beep (Piii...)
Tool is at an angle.
Tie with the tool facing directly
downward.
Continuous high & low
pitched chime (Pii poh
Pii poh...)
Internal structure; defect in internal
driving mechanism
Immediately discontinue operation and
set the Main switch (Fig.22.
e
) at "OFF"
and remove the Battery pack
(Fig.22.
5
) before consulting. Then
contact the dealer where the tool was
purchased or MAX CO., LTD.
authorized distributors.
Single-short beep (Popi)
WARNING
