9
WARNING:
WARNING:
4. INSTRUCTIONS FOR OPERATION
Read section titled SAFETY INSTRUCTIONS.
1.
BEFORE OPERATION
q Wear Safety Glasses or Goggles.
w Do not connect the air supply.
e Inspect screw tightness.
r Check operation of the contact arm & trigger if moving smoothly.
t Connect the air supply.
y Check the air-leakage. (The Tool must not have the air-leakage.)
u Hold the Tool with finger-off the trigger, then push the contact arm against the work-piece. (The
tool must not operate.)
i Hold the Tool with contact arm free from work-piece and pull the trigger. ( The Tool must not
operate.)
2. OPERATION
Wear safety glasses or goggles danger to the eyes always exists due to the possibility of dust being
blown up by the exhausted air or of a fastener flying up due to the improper handling of the tool. For
these reasons, safety glasses or goggles shall always be worn when operating the tool.
The employer and/or user must ensure that proper eye protection is worn. Eye protection equipment
must conform to the requirements of the American National Standards Institute, ANSI Z87.1 (Council
Directive 89/686/EEC of 21 DEC. 1989) and provide both frontal and side protection.
The employer is responsible to enforce the use of eye protection equipment by the tool operator and
all other personnel in the work area.
Keep hands and body away from the discharge outlet when driving the fasteners because of
dangerous of hitting the hands or body by mistake.
NAIL LOADING
q Open the magazine:
Hold door and door latch by fingers and pull up door latch. Swing door open. Swing
magazine cover open.
w When you want to use 17-19 mm nails, attach a nail support to the magazine.
Door latch
Magazine
Nail support
Door
