6
max
mobility
®
Button Mounting
The two (2) SmartDrive buttons are easily mounted to each side of the frame of the wheelchair to allow for easy pressing
without having to remove your hands from the handrims.
1.
Wrap the velcro loop around the rubber backing of the
button then around the side tubing of the wheelchair;
feed the skinny end of the velcro through the slot in the
wider end and pull tightly before laying down on its mat-
ing surface. Be sure the green LED is pointing up and
the cables that come out of each button run towards the
back of the wheelchair. The plug cable should hang over
the left front side of the seat (as shown below).
2.
Use the provided velcro strips to strap down the but-
ton cables to the upholstery, running the right button
cable around the back of the seat. Ideal placement of the
y-joint in the cable is shown to the right. Be be sure the
cable does not stick out and will not get caught in the
spokes of the wheelchair.
3.
Place the cushion over the cable to further secure it.
Again, the plug should hang over the left front side of
the seat upholstery and come out from under the cush-
ion.
NOTE: If the chair has screw-down seat upholstery, loosen
the screws and feed the velcro strap under the metal bar (then
retighten screws) to allow for closer positioning of the buttons to
the handrims.
