W
indy31
Q
uick
I
nstallation
G
uide
Trouble Shooting
33
2. Try reconnecting Windy31 to the host computer.
11. When Windy31 is connected to host computer, wireless signal
is weak and speed is slow.
Note: If Nero InCD/ DVD Ram Driver is installed in the host
computer, it may cause a conflict with Windy31 program.
Remove Nero InCD/DVD Ram driver from the host computer,
restart and reinstall Windy31.
12. No further process is made after installation of Windy31
program.
Make sure the device is in enabled mode.
[Start] → [Control Panel] → [System] → [Hardware] tab → [Device
Manager]
Right click on [Windy31] under Network Adapter and select
“Enable”as shown below.
13.
“
“
svchost.exe
”
”
error occurs during the usage of Windy31 or the
installation of Windy31 software.
Uninstall Windy31 program. Check your computer for any
viruses or spywares, and update the operating system with the
latest version. Then, reinstall Windy31.
W
ir
eless
B
roadband
R
outer
32
Trouble Shooting
5. During Installation, Windy31 enabler dialog box does not show
and installs as LAN Adapter mode.
Check service status in the windows service category WMI
(Windows Management Instrumentation). If there is problem in
WMI, Windy31 can’
t be configured in the Windows service.
Please check your computer, below.
* [Control Panel] → [Administrative Tools] → [Service and
Application] (Services in Vista) → Check if [WMI control status]
runs correctly.
6. Windy31 is installed completely and trying to connect to
Windy31 from another wireless device, connection is blocked or
not established.
Check if Windy31 is installed at personal firewall software
operating computer such as, Zone Alarm, McAfee Personal
Firewall, My Firewall, Sygate Personal Firewall, and etc.
Temporarily deactivate firewall program then reconnect
Windy31.
* To allow internet connection in firewall software program, refer
to your firewall software’
s Instruction Guide and User Manual.
7. Every time you restart your computer or reconnect Windy31,
Windy31 enabler automatically restarts.
If you restart your computer with Windy31 plugged-in, Windy31
Enabler automatically runs in order to check any changes in
the host PC network
8. Internet does not work on wireless client
’
’
s computer even
when it is connected to Windy31.
Please check IP Address of wireless client
[Start] → [Run] → type in
“cmd”→ type
“ipconfig/all”then you
can see IP address of wireless client. It must be 192.168.33.xxx
9. Wireless client cannot receive IP address even when firewall
and security setting is unblocked.
You must directly input IP address. Please refer to the
Installation Guide,
“Directly input IP address, page 27,28.
10. Internet on wireless client
’
’
s computer is suddenly
disconnected.
1. Make sure the power saving mode is turned off on host computer.
윈디31 메뉴얼 (150qn) 4도 2008.9.11 2:0 PM 페이지32
