MAV Sense IBEX-120, Manual

Page: 1 / 11

1
MAV Sense s.r.o.
Sládkova 372/8
702 00 Ostrava
Czech Republic
IBEX E
LECTRONIC
S
PEED
C
ONTROLLER
U
SER
M
ANUAL
F
IRMWARE
V
ERSION
1.06
The IBEX product line represents advanced speed controllers for use exclusively in RC airplane models. With
integrated telemetry and various possibilities of optional user configuration, the controllers offer high
efficiency, low weight and precise motor control.
F
EATURES
- Small dimensions combined with high power motor control.
- Over- and undervoltage protection, overtemperature protection, motor-stall protection.
- Configurable current limiter.
- Optically isolated throttle input.
- Safety shutdown when the throttle impulse is lost.
- Configurable acceleration, timing, electromagnetic brake etc.
- Low acoustic noise due to high frequency switching.
- Automatic telemetry detection: Duplex EX, Hott, MSB, S.Bus2. Alternative firmware with Spektrum
SRXL2 telemetry support.
- Telemetry (RC system dependent): voltage, current, power, capacity, temperature, RPM, energy.
- Telemetry min/max values are logged.
- Configuration through the transmitter or external terminal (JETIBOX/SMART-BOX).
- Firmware updates via USB interface.
- Languages: CZ/DE/EN/FR/IT.
IBEX-80 IBEX-120 IBEX-130 IBEX-220
Dimensions 57x35x28mm 58x53x24mm 58x53x28mm 81x63x36mm
Weight incl. cables 60g 110g 110g 270g
Continuous current 80A 120A 130A 220A
Peak current 120A/2s 160A/2s 180A/2s 280A
Supply voltage 8 – 51V 10 – 59V
(max. 64V)
10 – 51V 10 – 59V
(max. 64V)
LiPo cells 3 – 12 4 – 14 4 – 12 4 – 14
LiFe cells 3 – 14 4 – 16 4 – 14 4 – 16
Cables battery/motor 4mm
2
/2.5mm
2
4mm
2
/4mm
2
4mm
2
/4mm
2
6mm
2
/6mm
2
Anti-spark circuit No Yes Yes Yes
Recommended
connectors
G4 (75A)
XT90 (90A)
G5.5 (150A) G5.5 (150A) G8 (170A)
Temperature range -10÷110°C
PWM frequency 20kHz
Operating current 50mA 60mA
Standby current 4mA 10mA
Propeller positioning With additional Hall-sensor
Telemetry Duplex EX, Multiplex MSB, Graupner Hott, Futaba S.Bus2, Spektrum SRXL2
Status LED Yes
Active Freewheeling Yes
BEC No
Optical isolation Throttle input only Complete
Maximum RPM > 300 000 eRPM (2-pole motor)
I
NSTALLATION
Fasten the controller in your model by the screws. Alternatively, you can use Velcro or double-sided adhesive
tape for fixing. Connect the motor and receiver according to the schematic below. You may connect the motor
cables in arbitrary order, as changing direction is done by exchanging any of the two cables (alternatively also
by the “Direction” parameter in the configuration). Turn on the transmitter followed by the receiver – the
receiver uses a dedicated battery. Now you can plug in the main flight pack.
info@mavsense.com
www.mavsense.com