Matthews VIAcode T100, User Manual

Page: 31 / 47

27
T50/T100 PTM – User Guide – Version 2 Issue 1
Maintenance – Print Pause – Upto Two Weeks
To change the modulation setting, first select the desired T50/T100 and then tap the
Configure
button, as highlighted. Then tap the
Configure Cleaning
button from the
Configure
PTM
window, which will display the
Clean PWM
(Prime Width Modulation) window, as
shown.
The default value for the
Prime Width Modulation
is 80. Entering a greater value will
increase the ink flow rate. A value less than the default value will decrease the flow rate.
Print Pause – Upto Two Weeks
Caution
If a PTM is to be moved/adjusted in any way that would disturb its stationary status it
must be prepared as described under "Moving, Storing, or Shipping a PTM".
• If a PTM is to be remain inactive, leave the power supply ON. This will ensure that the
Gutter Clean interval
(
Automatic Cleaning
) can function and the PTM is kept in good
working order.
The PTM must remain stationary!
• If the power supply has to be disconnected put a rag under the print head’s nozzles as ink
can leak.
The PTM must remain stationary!
The
Gutter Clean Interval
is set from within the PCM’s
Configuration
menu. First select
Print Heads,
then the relevant
Marker,
and finally its
Advanced
options. It is recommended
that the
Gutter Clean Interval
is always used.
Using the
Gutter Clean Interval e
nsures that ink does not build up around the gutter. Any
expelled ink that resides in the gutter will be sucked back into the ink system. For further
information refer to the PCM’s Technical Manual.
Moving, Storing, or Shipping a PTM
Caution
PTMs must be correctly prepared before: moving them in any way that would disturb
their stationary status, storing them, or shipping them. Failure to correctly prepare
them will lead to printing problems that can be difficult to resolve. The PTM’s warranty
will become void if a head is damaged as a result of not being correctly prepared.
Procedure – Preparing for: Moving, Storing, or Shipping
1. Press and hold the
PRIME
button on the back of the PTM for one second and then
release it. Refer to “External Components” on page 6.
2. Disconnect all cables from the PTM.
3. Clean the
Nozzle-Protector-Plate
with a lint free cloth and then screw it on to the front of
the PTM, finger tight. Make sure that it is mounted so the text "Gutter", that is printed on
the plate, is positioned at the bottom of the nozzles. It should be mounted as shown in
Figure 25 on page 30.