Matthews VIAcode T100, User Manual, Page: 18 / 47

Installation – Print Head Set-up
T50/T100 PTM – User Guide – Version 2 Issue 1
14
1. Make sure that the
Ink-Vent-Screw
is closed and that the
Nozzle-Protector-Plate
is
correctly attached to the print head.
Caution: Failure to close the Ink-Vent-Screw and attach the Nozzle-Protector-Plate
will result in ink spillage or air becoming trapped in the system
Figure 8 - Changing the head set-up.
2. Disconnect all cables and make sure that there is no power supplied to the print head.
3. Unscrew and remove the
Ink-Bottle
from the
Ink-Reservoir
.
4. Screw the
Ink-Reservoir-Cap
in to the
Ink-Inlet
, so that no ink is spilt.
Caution: Ink spillage will occur if the Ink-Reservoir-Cap is not correctly inserted.
Figure 9 - Removing the
Reservoir-Cover
5. Unscrew and remove the five screws that retain the
Reservoir-Cover
, as shown above.
6. Place the print head so that it is level. Unscrew the
Ink-Reservoir-Cap
and then remove
the
Reservoir-Cover.
Screw the
Ink-Reservoir-Cap
back in to the
Ink-Inlet
once the cover
has been removed.
Nozzle-Protector-Plate
Ink-Vent-Screw
Reservoir-Cover
Ink-Reservoir-Cap
Ink-Reservoir
screws
Ink-Inlet