Monarch EDGE Control Hub configuration
| 42 |
Part # V11470-301-0101
Last updated: July 27, 2020
Routing scheme
Select one of the following:
•
Multicast
Enter
a
Multicast address
. Using multicast
may require additional network configuration to support
the transmission protocol (some network switches and
routers can block multicast signals). For more informa-
tion, contact your network administrator. To also allow
unicast connections, enable the
Allow unicast connec-
tions
option.
•
Unicast
When selecting unicast, you need to specify the
destination IP address of the stream. You can enter a valid
IP address or host name.
SRT
1
Enable stream
Enables the SRT stream to the specified location.
Base port
The port you are transmitting to on the receiving device.
Name
Enter a name for your stream.
Network interface
Select LAN1 or LAN2
Encryption
Select one of the following:
•
Unencrypted
•
AES-128
•
AES-192
•
AES-256
Passphrase
When using encryption, this is the passphrase used to generate the
encryption key. We recommend a passphrase length of 16 charac-
ters (AES-128), 24 characters (AES-192), and 32 characters (AES-
256).
Latency
The target latency, in milliseconds (ms), for transmission. The
default is 40 ms.
Time to live
The number of hops or network nodes (such as network switches
or routers) through which a multicast signal can travel. Once the
TTL number is reached, the receiving network node prevents the
signal broadcast further down the network. The value ranges from
1 to 255. The default is 16.
Routing scheme
Only
unicast
is available. You must specify a unicast address. You
can enter a valid IP address or host name. The SRT protocol prefix
(srt://) and the base port suffix (:9000) aren’t required when enter-
ing a host name as the unicast address.
1. When using the SRT streaming protocol, you may experience a few frames of misaligned video when
attempting to decode four streams. However, this misaligned video may not be visibly noticeable.
Setting
Description