Status LEDs on Matrox Rapixo CXP 67
Board status LEDs
Matrox Rapixo CXP has four board status LEDs to indicate the status of the board:
board-power good, board configuration, PCIe speed/#lanes, and fallback board
configuration.
The table below outlines the possible colors for each LED and their definitions.
Board-p
good
ower
Board configuration
PCIe speed/# lanes
Fallback board configuration
LEDs
1
4
3
2
1
2
3
4
LED
LED color and state
Description
1. Board-power good
Off/Red
One or more of the on-board voltage regulators did not start.
If your computer is on and this LED state occurs, there is an issue with the voltage regulators
on your Matrox Rapixo CXP. Contact Matrox technical support.
Green
All of the on-board voltage regulators are working properly.
2. Board configuration
Red
The board is not configured.
Green
The board is configured.
3. PCIe speed/# lanes
Off
The type of slot cannot be established. The PCIe link is down.
Blinking red
Slot is PCIe 1.x, less than x8
Blinking orange
Slot is PCIe 2.x, less than x8
Blinking green
Slot is PCIe 3.x, less than x8
Solid red
Slot is PCIe 1.x, x8
Solid orange
Slot is PCIe 2.x, x8
Solid green
Slot is PCIe 3.x, x8
4. fallback board
configuration
Off
The normal board configuration is being used.
On
The normal board configuration was corrupt. The fallback (golden) board configuration is
being used.
Summary of Contents for Matrox Rapixo CXP
