Matrox DigiSuite LX MAX, User & Installation Manual

Page: 42 / 160

30
Chapter 4, Installing Your DigiSuite LX MAX Hardware
Connect the digital module internal cable
The digital module internal cable is made up of a large cable with video
and audio connectors and a smaller cable with standard internal device
power connectors (similar to the ones you would use to power an internal
CD unit or hard drive).
°Important Remember that the digital module internal cable should
remain connected to the module at all times. Do not try to remove the
internal cable from the digital module or tamper with the audio and video
connectors on the module.
1
Connect the internal video/audio cable to one of the free slots at the
back of your computer. Make sure that there are no sharp, right-angle
bends in the cable. Secure the cable’s back plate to the computer.
2
Connect the appropriate power connector to your power source.
°Important Make sure you connect the power connector before starting
up your system for the first time.
MAX
Back of computer
To power
source
Digital module
DigiSuite LX
Video/audio cable
Movie-2 bus
connector