Matrox DigiSuite LX MAX, User & Installation Manual

Page: 39 / 160

27
Mount your optional digital module on DigiSuite LX
Mount your optional digital module on DigiSuite LX
¯Note
Before proceeding, you should review the antistatic and safety
precautions described earlier on page 20 .
If you’re upgrading to the DigiSuite LX MAX digital module (that is, if
you already have DigiSuite LX MAX installed in your system and wish to
add the digital module), refer to the
Digital Module Upgrade for DigiSuite
DTV/LX Quick Installation for complete installation procedures. This sheet
is supplied with the digital module.
1 Lay DigiSuite LX on a flat surface so that the module board (chip
side) is facing up.
2 Carefully align the three plastic pins on the digital module with the
three mounting holes in the DigiSuite LX card, and snap the module
into place.
Assemble and install your DigiSuite LX MAX card set
°Important
Be sure your VIP cable is connected to your Matrox MAX
card as explained in “Connect the VIP cable to your MAX card” on
page 24 . If you assemble your card set without the cable already
connected, you won’t be able to connect it afterwards!
1 If any of the slots in which you’ll be installing your DigiSuite cards
already contain other cards, either move them to unused slots or
remove them completely.
2 Remove the metal plate located at the back of each slot you’ll be
using. Don’t lose the screws as you’ll need them to fasten the cards
later on.
3 Make sure the termination switch on your DigiSuite LX is set to the
proper position, as explained in
“Set the termination switch on
DigiSuite LX” on page 24 . Also, make sure you’ve removed the PCI
retainer brackets, as indicated in “Removing the PCI retainer bracket”
on page 23 , if necessary.
4 The connectors for the cards are indicated on the top of the Movie-2
bus.