Matrox DigiSuite LX MAX, User & Installation Manual

Page: 36 / 160

24
Chapter 4, Installing Your DigiSuite LX MAX Hardware
Set the termination switch on DigiSuite LX
DigiSuite LX provides a DIP switch for 75-ohm blackburst termination for
the REF IN connection. This is located at the top of the module board near
the connection end of the card.
Normally, you should set both switches to the position marked “ON”
before installing DigiSuite LX in your system. If you’re using the
DigiConnect/Video breakout box or another device for termination,
however, set both termination switches to Hi Z.
Connect the VIP cable to your MAX card
If your VIP cable was not shipped already attached to your Matrox MAX
card, you
must attach one end of the VIP cable to the connector on the
component side of your MAX card before you assemble your card set.
Make sure that the red edge of the cable is connected towards the top of the
card (closest to the Movie-2 bus connector).
Switch position
for Hi Z
(required for use with
DigiConnect/Video)
Switches 1 and 2 in “ON” position for
75 termination Ω
O N O N
1
2
Boogie
O
ogie Oog
ie!
Boogie
Oogie
Oogie!