![Matrox DigiSuite DigiMix Installation & Reference Manual Download Page 18](http://html1.mh-extra.com/html/matrox/digisuite-digimix/digisuite-digimix_installation-and-reference-manual_1741455018.webp)
12
Chapter 2: Installing DigiMix
Set your termination switch
DigiMix provides a DIP switch for 75
Ω
blackburst termination for the
REF IN connection. This is located at the top of the base board near the
connection end of the card.
Normally, you should set this switch to the position marked “75” before
installing DigiMix in your system.
Use the PCI retainer brackets
Almost all computers contain card guides at the front end of the computer
chassis. These help to stabilize cards. Since PCI cards are neither long
enough nor correctly centered to use these guides, some of the PCI-based
DigiSuite cards are equipped with a PCI retainer bracket. The following
diagram depicts the retainer bracket’s use:
Switch 1 position for
75
termination
W
Switch 1 position
for Hi Z
Switch 2 (not used)
DigiSuite card’s
module board
DigiSuite card’s
base board
ISA card guide
PCI retainer
bracket
Summary of Contents for DigiSuite DigiMix
