Matrox 4Sight EV6, Installation And Hardware Reference

Page: 23 / 116

Operating your Matrox 4Sight EV6 for the first time 23
5. Turn the unit on using the power button on the back panel.
The default language is English. Additional display languages are provided, but
must be installed using the OSConfig utility, accessible from the Windows Start
menu. You can add or remove languages using this utility. Windows assumes that
your keyboard language is the same as the language you selected. For more details,
click on the
More Info button.
6. Verify that your connected devices are operating correctly.
Once your devices are operational, you can power down the unit to connect more
devices to the motherboard, networking interface, or connect devices to the
auxiliary I/O interface. For information on connecting devices to the auxiliary
I/O interface, refer to the
Connecting to the auxiliary I/O interface section, later in
this chapter. For information on adding hardware to the Matrox 4Sight EV6
motherboard, refer to
Chapter 3: Adding devices to Matrox 4Sight EV6 .
Turning off the Matrox 4Sight EV6 unit
To turn off the Matrox 4Sight EV6 unit, press the power button. You can also
shut down the unit by shutting down Windows with the
Shut Down command.
If the unit does not respond to the above methods, push and hold the power button
until the unit shuts down.
Caution
Be sure to turn off the power to the unit and all peripherals, as well as unplug the
power from the unit before adding or removing devices.
Rebooting the unit
When the unit is on, you can reboot the unit using one of the two following
techniques:
• Press the Control-Alt-Delete keys on your keyboard simultaneously.
• Press the power button to turn the unit off, and then press the power button to
turn the unit on again.
If you need to enter the UEFI Setup utility, you must press the Esc key during
power-on self-test (POST). You only have a few moments to press the Esc key
before the boot-up process continues.