11
saw blade flange, observing the turning
direction of the saw blade.
• Put the outer saw blade flange in place
and firmly tighten the screw.
• Return the saw blade guard to the correct
position.
Electrical Connection
The mitre saw's electric motor is
completely wired ready for operation.
The customer’s connection to the power
supply system, and any extension
cables that may be used, must comply
with local regulations.
Important:
The motor is automatically switched off in
the event of an overload. The motor can
be switched on again after a cooling down
period that can vary.
Defective Electrical Connection Cables
Electrical connection cables often suffer
insulation damage.
Possible causes are:
• Pinch points when connection cables are
run through window or door gaps.
• Kinks resulting from incorrect attachment
or laying of the connection cable.
• Cuts resulting from running over the
connecting cable.
• Insulation damage resulting from forcefully
pulling out of the wall socket.
• Cracks through aging of insulation.
Such defective electrical connection cables
must not be used as the insulation damage
makes them
extremely hazardous.
Check electrical connection cables regularly
for damage.
Make sure the cable is disconnected from
the mains when checking.
Electrical connection cables must comply
with the regulations applicable in your
country.
Single-phase Motor
• The mains voltage must match the voltage
specified on the motor’s rating plate.
• Extension cables up to a length of 25 m
must have a cross-section of 1.5 mm
2
, and
beyond 25 m at least 2.5 mm
2
.
• The connection to the mains must be
protected with a 16 A slow-acting fuse.
Only a qualified electrician is permitted to
connect the machine and complete repairs
on its electrical equipment.
In the event of enquiries please specify the
following data:
• Motor manufacturer
• Type of motor voltage
• Data recorded on the machine’s rating
plate
• Data recorded on the switch’s rating plate
If a motor has to be returned, it must always
be dispatched with the complete driving unit
and switch.
Accessories
SAWDUST SUCTION REMOVAL SYSTEM
The mitre saw is equipped with a suction
connector, so that it can be connected to a
suction system. Optionally, a dust bag can
also be installed.
The hose of the suction system is fastened
to the suction connector with a hose clamp.
We recommend that you empty the bag or
the container of the suction assembly
from time to time and clean the filter.
The air flow rate of the suction system must
be at least 30 m per second.
Maintenance
If service personnel must be brought in
for exceptional service or repairs during
the warranty period and thereafter,
please contact a service provider
recommended by us or contact the
manufacturer directly.
• Overhauls, maintenance work,
cleaning, as well as the elimination of any
malfunctions must only be undertaken after
