50
- Lubricate all moving parts at regular
intervals.
- If necessary, clean the tool housing with
a soft, damp cloth. A mild detergent may
be used a mild detergent, but alcohol,
gasoline or other aggressive cleaners
should never be used.
- Never use caustic agents when cleaning
plastic parts.
CAUTION:
Water should not come in
contact with the tool.
3. General inspection
Check if all fixing screws are tight on a
regular basis. Pay special attention to the
outer flange. The vibration can loosen
screws over time.
Check the power cord of the unit and all
extension cords used for damage on a
regular basis. Get the power cord replaced
by an authorized service center if the
damage is detected.
Replace damaged extension cords.
4. Lubrication
The grease in the gear unit of the tool must
be changed, after extended use. Contact a
contract workshop for more information.
13. TECHNICAL SPECIFICATIONS
This tool is double-insulated. It has two
independent insulation for protection
against electric shock.
Tension:
230-240 V ~ / 50 Hz
Power input:
1800 W
Idle speed
4500 min
-1
Gross weight : 12.7 kg
Net weight: 10.6 kg
Saw blade
Ø 216 mm x Ø 30 mm x 2.8 mm, 24 T
Angle of mitre table:
-45°/0°/+45°
Workpiece size:
0°x 0°: 65 x 340 mm
0° x 45°: 65 x 240 mm
45° x 45°: 40 x 240 mm
45° x 0°: 40 x 340 mm
Information on the development of noise
and vibration
A-weighted sound pressure level L
PA
:
99,21 dB(A)
A-weighted sound power level L
WA
:
112,21 dB(A) K=3 dB(A)
Vibrations:
< 2.5 m/s
2
, K=1.5 m/s
2
Warning!
The vibration emission value indicated
was measured as per a standardized test
procedure and may vary, depending on the
type and manner in which the power tool
is used and in exceptional cases exceed the
declared value.
The vibration emission value indicated can
be used to compare one power tool with
another.
The vibration emission value indicated can
be also used for an initial assessment of the
impairment.
Restrict the sound development and
vibration on a minimum!
- Use only flawless devices. Maintain and
clean the device regularly.
- Adapt your mode of operation the device.
- Do not overburden the device.
- Get the device checked if necessary.
- Turn off the device when not in use.
Use only accessories and spare parts
recommended by the manufacturer. If the
device breaks down despite our quality
control and your care, get it repaired only
by an authorized electrical specialist.
Other risks
Even if you operate this power tool properly,
there will still be other risks. The following
UK
Summary of Contents for 210.200.356
Page 2: ...2 7 1 5 23 14 12 31 30 22 24 19 32 11 13 16 10 27 28 29 26 15 9 35 33 18 36 21 1 ...
Page 3: ...3 7 2 4 8 6 17 2 3 4 25 34 32 35 33 ...
Page 4: ...4 15 26 18 13 18 29 29 31 30 30 16 19 20 22 21 6 5 7 9 11 6 8 10 12 ...
Page 5: ...5 27 28 1 3 10 11 13 15 17 19 14 16 18 20 ...
