MSC-UTX62L Product Manual
ctl.serial.baud
Number RW
AS First serial port baud rate in bits/second.
ctl.serial.log
Boolean RW
AS First serial port protocol log enable.
ctl.serial.proto
String
RW
AS First serial port protocol selection (“mascot”, “svs”, etc).
ctl.serial2.baud Number RW
AS Second serial port baud rate in bits/second.
ctl.serial2.log
Boolean RW
AS Second serial port protocol log enable.
ctl.serial2.proto String
RW
AS Second serial port protocol selection (“mascot”, “svs”, etc).
mtx.serial
Number R
Current matrix serial number, incremented on every routing change.
mtx.sync
Boolean RW
AS Keep current routing state stored to preset 0. Effectively retains last
matrix routing state even after a restart or power cycle.
net.dhcp
Boolean RW
S
Network interface DHCP enable.
net.gateway
IP
RW
S
Network gateway address.
net.ip
IP
RW
S
Network interface IP address.
net.mac
MAC
R
Network interface MAC address.
net.netmask
IP
RW
S
Network interface mask.
pnl.cmdEn
Boolean RW
AS Panel command macro enable.
pnl.ip
IP
RW
AS Remote IP address for panel interface to control.
sys.arch
String
R
System architecture (“Pyxis”, “Carina”, “Lynx”, etc).
sys.firmware
String
R
Firmware series and version (“Pyxis 1.1.7” for example).
sys.name
String
RW
AS System name identifier.
3.8 Core Commands
This section outlines commands considered to be core MASCOT protocol commands and consists of matrix
routing, I/O label, preset, and other primary system commands.
Command
Arguments
Description
[Dest][Lvl][Label]
Destination I/O names command.
[0 | 1]
Matrix connection echo enable command.
System firmware version.
Command help reference.
Mascot protocol version.
[0-7]
Current matrix config.
[Preset]
Recall a preset.
(Preset)(Dest)(Src)[Lvl]
Add a connection to a preset.
(Preset)
Clear a preset to “No Change” values.
[Preset][Label]
Preset names command.
(Preset)(Dest)[Lvl]
Subtract a connection from a preset.
[Preset]
View preset.
Quit
Quit TCP/IP telnet session.
Reboot the system.
Page 24 of 60
© 2013-2020 Matrix Switch Corporation
