8
22. Set the anti-curl to the desired
setting - suggested starting position 2-3,
if the print curls up increase the anti-curl
number, if down decrease.
23. Set the perforation wheel, lock in
place on the edge of the film which
should be in the paper margin (and not
on the print).
24. Turn the screw as the paper is feeding
until the perforation wheel starts to turn,
then lock into position.
25. Set the guide wheel to the opposite
side of the sheet from the perforation
wheel.
26. Finally, set the incline wheel on the
edge of the print on the same side as
the perforation wheel. Only a very small
angle is required.
21. Lower the laminating and pull rollers.
Press pull roller switch. Roller will lower
and light should illuminate.
