SAFETY INFORMATION
1.
Matrix Mirrors fixtures must be installed in accordance with
all applicable national, state, and local electrical codes and by a
licensed electrician.
2.
TO AVOID THE RISK OF SHOCK OR FIRE, DISCONNECT POW
-
ER BEFORE INSTALLATION.
3.
Recommended two-person installation. This is especially
important for mirrors larger than 24x36 | For mirrors larger
than 36x60, consider having a glass professional present for the
installation.
4.
NEVER grasp the mirror chassis or glass by the corners; they
are sharp and can cause injury.
5.
Matrix Mirrors hanging brackets must be installed into studs
or blocking. Sheet rock alone is insufficient; a mirror could fall if
not properly installed in accordance with these instructions.
6.
Matrix Mirrors is not responsible for damage or injury in
-
curred during the installation process or for problems that arise
if its products should be installed by an unlicensed person. See
the full Matrix Mirrors Warranty Statement and Terms and
Conditions on matrixmirrors.com.
DO NOT BEGIN THE INSTALLATION WITHOUT
FIRST READING ALL SAFETY, HANDLING, AND
CARE INSTRUCTIONS
HANDLING INSTRUCTIONS
1.
Never place the mirror chassis or glass on any surface by any
of the four corners. This can lead to damage or breakage.
2.
If the mirror must be removed from the wall, be sure to
first disconnect the power, then remove the glass before
dismounting the chassis.
3.
Do not place the glass down on any hard surfaces such as
hardwood, tile, granite, concrete, vinyl, or linoleum.
4.
When storing the glass either during installation or re
-
moval, always place two corners flush against the floor and
two against a wall. All surfaces should be covered by a soft
barrier such as foam, double-walled cardboard, a towel, or
a blanket. It is also possible to lay the glass completely flat
against a soft surface
CARE INSTRUCTIONS
1.
If possible, turn off power to the mirror before cleaning.
2.
Do not clean using abrasive cloths or paper towels as they
can scratch the glass.
3.
Do not spray chemicals or liquids on any part of the mirror
- particularly the sides or edges of the glass and the diffusers
along the sides of the mirror chassis.
To clean the glass, apply
a glass cleaning agent to a non-abrasive or microfiber cloth,
then gently wipe the glass and sides, being careful not to
touch the corners of the glass or the chassis
.
4.
Never apply pressure, pull down, or push up on the glass or
chassis as this could cause injury or damage.
5.
No one other than a licensed and trained electrician should
ever remove the mirror glass from the chassis or uninstall the
chassis from the wall.
BEFORE INSTALLING
The hanging orientation of the mirror should have been
specified before ordering as “Vertical” or “Universal.”
Mirrors specified as “Vertical” have 2 brackets affixed to
the back of the mirror. “Universal” Mirrors have 3 brackets
affixed to the back. As pictured below. “Universal” models
can be hung horizontally or vertically.
Vertical
Universal