Maintenance
Page 41
Fig. 65: Lowering safeguard in
secured position
6.
Remove the belt guard.
7.
Remove the mounting screws on the bearing bracket.
8.
Loosen the lock nut of the set screw.
9.
Adjust the tension of the belt by turning the set screw (see Fig. 66).
Fig. 66: Tension the V-belt
10. Tighten the lock nut.
11. Tighten the mounting screws on the bearing bracket.
12. Mount the belt guard.
13. Unhook the lowering safeguard.
14. Lower the collection bin.
8.1.7
Adjusting the seal of the collection bin cover
Danger!
The implement can tip over.
Only perform service and maintenance tasks if,
the CLS is on level ground,
the CLS is mounted on the tractor and
the collection bin is empty.
Lowering safeguard hooked in
Set screw
Bearing bracket
