Maintenance
Page 37
8
Maintenance
8.1
Service
Danger!
The implement can tip over.
Only perform service and maintenance tasks if,
the CLS is on level ground,
the CLS is mounted on the tractor and
the collection bin is empty.
Danger!
The operator and other persons can be severely injured.
Only perform service and maintenance tasks with lifted bin if the bin has
been safeguarded against falling unintentionally by appropriately position-
ing the lowering safeguard. Do not forget to unhook the lowering safeguard
before lowering the bin.
8.1.1
General
Attention!
Properly re-attach all protective devices that have been dismounted after
executing the service tasks.
Note!
After the first 20 hours of operation check all screw and bolt connections.
Regularly service the CLS as described in section 8.1.3.
Only use lubricating grease, do not use oil to lubricate moving parts.
8.1.2
Daily service
Check the safety elements and moving parts for wear.
Replace worn or defective parts.
Check the hydraulic connections and lines for leaks.
Replace leaking connections and lines.
Lubricate the bearing block of the turbine drive.
Proceed as described in section 8.1.6.
Execute a trial run.
For the chassis version, check the air pressure of the pivot wheels and adjust the air
pressure if necessary.
Clean the entire implement after each use.
Particularly clean the bin the turbine, the suction hose and the suction connector
from the inside.
8.1.3
Service schedule (overview)
