Operation
Page 34
7
Operation
7.1
Starting and switching off the turbine
Danger!
A rotating turbine can cause severe injuries.
The turbine continues to rotate for a short time after it is switched off.
Wait until the turbine has come to a standstill before executing maintenance
or conversion tasks. The afterrun times vary based on the tractor/implement
combination.
The turbine is driven by the rear universal joint shaft on the tractor. Its task is to take up the cut-
tings from the rotary motor via a suction line and transport the cuttings into the bin via the pres-
sure line.
The process of switching the rear PTO shaft on and off varies depending on tractor type
(see the tractor operating manual in this regard).
Switching on the rear PTO shaft means: The turbine is running.
Switching off the rear PTO shaft means: The turbine will come to a standstill.
7.2
Lifting, lowering, and emptying the collection bin
Danger!
The operator or persons near the tractor/implement can be severely injured.
Comply with the following instructions when lifting and lowering the collec-
tion bin:
Ensure that no one is in the danger zone.
The material collection system can tilt. The tractor must be on a firm and
level substrate when you empty the collection bin.
The procedures for emptying the CLS-G/H 650/850 differ depending on the version:
High-dump version or low-dump version
7.2.1
Low-dump
The CLS-G/H 650/850 is emptied from the driver seat via activation of the tractor's hydraulic
system.
1.
Approach the dump point with the tractor in reverse.
2.
Activate the tractor's hydraulic system to open the cover.
The cuttings will fall out.
