Matelec FPC-12725, Owner'S Operation Manual

Page: 3 / 8

INSTALLATION
3
FRONT SIDE VIEW
Top
Bottom
Top
Bottom
CONNECTION
MOUNTING
DOC: FPC 12725
VER: 1.1
WIRING CONNECTION DETAIL
FPC-12725
WARNING: HIGH VOLTAGE
ALL ELECTRICAL CONNECTIONS MUST BE CARRIED OUT
BY A SUITABLY QUALIFIED ELECTRICIAN
ACCESS BY AUTHORISED PERSONNEL ONLY
INTERFACE KEYPAD GUIDE
PUMP
415Vac
MAINS POWER
SUPPLY
LOW SUPPLY
FLOAT SWITCH
BLUE
NOT
REQUIRED
COMMON
N/O C
LOSE ON RISE
INSERT LOOP
IF NOT
REQUIRED
®
Australia
PULSE LATCHING
DC SOLENOID
VALVE
VALVE
+ -
PUMP SUPPLY
PRESS
SWITCH
FLOAT
SWITCH
INPUT
SOLENOID
415Vac 12Vdc
E A1 N E A1 N A2 A3 A2 A3
ON STEADY
Rain/Tank Water is in use
FLASHING
The Pump is Running
ON STEADY
Mains/Town Water is in use
Press to reset fault or momentary change valve state
SYSTEM
TEST
RAIN WATER
MAINS WATER
SYSTEM FAULT
ON STEADY
Either a Pump (overload) or a Prime Loss (if setup) Fault has occured
WIRING CONNECTION DETAIL
FPC-12725
WARNING: HIGH VOLTAGE
ALL ELECTRICAL CONNECTIONS MUST BE CARRIED OUT
BY A SUITABLY QUALIFIED ELECTRICIAN
ACCESS BY AUTHORISED PERSONNEL ONLY
INTERFACE KEYPAD GUIDE
PUMP
415Vac
MAINS POWER
SUPPLY
LOW SUPPLY
FLOAT SWITCH
BLUE
NOT
REQUIRED
COMMON
N/O C
LOSE ON RISE
INSERT LOOP
IF NOT
REQUIRED
®
Australia
PULSE LATCHING
DC SOLENOID
VALVE
VALVE
+ -
PUMP SUPPLY
PRESS
SWITCH
FLOAT
SWITCH
INPUT
SOLENOID
415Vac 12Vdc
E A1 N E A1 N A2 A3 A2 A3
ON STEADY
Rain/Tank Water is in use
FLASHING
The Pump is Running
ON STEADY
Mains/Town Water is in use
Press to reset fault or momentary change valve state
SYSTEM
TEST
RAIN WATER
MAINS WATER
SYSTEM FAULT
ON STEADY
Either a Pump (overload) or a Prime Loss (if setup) Fault has occured
Mounting
Frame/
Wall
MAIN ISOLATOR
1. Controller enclosure must be
mounted in a vertical position.
2. Ensure mounting method does
not compromise enclosure
weather proof rating.
3. Ensure access to main isolator is
not restricted.
4. Ensure cables/conduits entering
the panel have mechanical
protection and that the
penetrations are sealed and do
not compromise the weather
proof rating of the enclosure.
Note: Controller must be earthed and all electrical connections must be carried out by a suitably qualified Electrician.