Aug.2019 Rev 1.0
www.mateksys.com
VTX CLI command
1. Connect VTX TX/RX to one of FC UART
VTX RX to FC TX, VTX TX to FC RX, Common ground
2. Connect FC USB to your computer
3. Connect FC to BF configurator
4. Power ON VTX
5. Type Serialpassthrough code in CLI & press the keyboard “Enter”
If using the FC UART1, Type “
Serialpassthrough 0 115200
”
......
If using the FC UART6, Type “
Serialpassthrough 5 115200
”
*** Following command is in VTX firmware,
It is not related to BF command
6. Type “
help
” after FC forward the port
7. Type “
config list
” to check VTX setting
E4_5645 and E8_5945 are disabled by default
8. Type “
set freq 5645 = enable
” to enable E4
Type “
set freq 5945 = enable
” to enable E8
9. You can also enable/disable whole band
e.g. “
set band A = disable
”
10. If Freq/band is disabled, button control will jump over it.
11. Unplug USB & battery,
Serialpassthrough mode will be invalid.
MCU
STM32F722RET6
SH1.0-8P
DFU
ICM
20602
