The Mate Logo and ULTRA TEC are registered trademarks of Mate Precision Tooling Inc.
Mate Precision Tooling • 1295 Lund Boulevard • Anoka, Minnesota 55303 USA • Phone 763.421.0230 • 800.328.4492 • Fax 763.421.0285 • 800.541.0285
©2003 Mate Precision Tooling
LIT00036
Installation/Length Adjustment Ultra TEC
®
1 1/4” B Station Fully Guided Assembly
PLACE PUNCH GUIDE ASSEMBLY
ON WORK SURFACE WITH
STRIPPER FACING UP...
INSERT TIP OF CLIP TOOL INTO
NOTCH ON CLIP (VISIBLE IN
PUNCH GUIDE CUTAWAY)…
Push latch pin down
with tool. Latch pin
will release stripper
clip, which will pop out
ready for removal of
the stripper.
NOTE: Stripper clip is assembled
with the guide and is not
removable.
PUNCH END VIEW
NOTE: Head of latch pin is visible in the notch
cut into the stripper clip.
ROTATE CANISTER TO INCREASE
LENGTH ADJUSTMENT…
Shoulder of punch will lift
stripper partially out of punch
guide. Do not attempt to pry
or lever stripper out of punch
guide. Rotate canister until
punch threads disengage.
Then turn assembly upside
down while supporting the
punch with one hand. Punch
and stripper will now drop out
of punch guide into your
hand.
ALIGN CANISTER…
Turn canister assembly until index mark is
aligned with the push buttons on the
punch guide.
DEPRESS BUTTONS AND
PULL ASSEMBLY APART…
Hint: The best way to
overcome button spring
pressure when
disassembling is to fully
depress your index finger
button and then your
thumb button. Following
this sequence will make
disassembly faster and
easier.
