MT2827
3
03/23/09
MT2827 1/2" Composite Reversible Air Drill
air supply
Tools of this class operate on a wide range of air pressures. It is
recommended that air pressure of these tools measures 90 PSI
at the tool while running free. Higher pressure and unclean air will
shorten tool life because of faster wear and may create a
hazardous condition.
Water in the air line will cause damage to the tool. Drain the air tank daily.
Clean the air inlet filter screen on at least a weekly schedule. The
recommended hook-up procedure can be viewed in Figure 1.
The air inlet (Figure 2), used for connecting air supply, has standard 1/4" NPT
American Thread.
Line pressure should be increased to compensate for unusually
long air hoses (over 25 feet). Minimum hose diameter should be 3/8" I.D. and
fittings should have the same inside dimensions.
TrouBleshooTing
Other factors outside the tool may cause loss of power or erratic action.
Reduced compressor output, excessive drain on the air line, moisture or
restrictions in air pipes or the use of hose connections of improper size or poor
conditions may reduce air supply. If outside conditions are in order and the
tool still performs erratically, disconnect tool from hose and take tool to your
nearest Matco authorized service center.
luBricaTion & MainTenance
Lubricate the tool daily with a good grade of air tool oil. If no
air line oiler is used, run 1/2 oz. of oil through the tool. The oil can be squirted
into the tool air inlet Figure 2, or into the hose at the nearest connection to the
air supply, then run the tool. A rust inhibitive oil is acceptable for air tools.
WarranTy
Matco warrants its air tools for a period of 1 year to the consumer. We will
repair any MT Series air tool covered under this warranty which proves to
be defective in material or workmanship during the warranty period. In order
to have your tool repaired, return the tool to any Matco Authorized Warranty
Center listed, freight prepaid. Please include a copy of your proof of purchase
and a brief description of the problem. The tool will be inspected and if any part
or parts are found to be defective in material or workmanship, the tool will be
repaired free of charge and returned to you freight prepaid.
This warranty gives you specific rights. You may also have other rights which
vary from state to state.
The foregoing obligation is Matco’s sole liability under this or any implied
warranty and under no circumstances shall Matco be liable for any incidental
or consequential damages.
Note:
Some states do not allow the exclusion or limitation of
incidental or consequential damages so the above limitation or exclusion may
not apply to you.
MaTco air coMMand
Tool Repair SV
1330 Commerce Dr.
Stow, OH 44224
(800) 433-7098
discounT Tool repair
3433 Losee Rd. #1
North Las Vegas, NV 89030
(702) 657-6570
pneuTool parTs and serVice co. lTd.
33 Haas Rd.
Toronto, ON M9W 3A1 Canada
(416) 748-1200
(888) 748-1201 Toll Free In Canada
Nipple
fig. 1
fig. 2
feaTures
• 1/2" composite drill with industrial grade chuck.
• Spring loaded vanes provide low torque operation and stall torque
resistance while variable speed trigger allows for precise speed control.
• Ergonomic chemical resistant composite housing.
• Convenient side forward/reverse lever makes changing directions easy.
• Side handle for heavy duty use.
air inleT
VariaBle speed
Trigger
