Model # MFJ2QL 2 Ton Capacity Heavy Duty Quick To Load Service Jack
4
Rev. 10/11/01
Warranty Notice...
Hydraulic Warranty Policy
Matco shop equipment and tools, excluding
accessories, are warranted against defects in
materials or workmanship for a period of 1 year
from original purchase. We will repair or replace
at our option any defective part or unit which
proves to be defective in material or workmanship
within this warranty plan. This warranty does not
cover damage to equipment or tools arising from
alteration, abuse or misuse, and does not cover
any repairs or replacement made by anyone
other than Matco or its authorized service cen-
ters.
The foregoing obligation is Matco Tools sole lia-
bility under this or any implied warranty and
under no circumstances shall we be liable for any
incidental or consequential damages.
NOTE: Some states do not allow the exclusion or
limitation of incidental or consequential damages,
so the above limitation or exclusion may not apply
to you.
Return equipment or parts to Matco Tools, or an
authorized service center, transportation prepaid.
Be certain to include your name and address, evi-
dence of the purchase date, and description of
the suspected defect.
If you have any questions about warranty
service, please write to Matco Tools, Stow, OH
44224. This warranty gives you specific legal
rights and you may also have other rights which
vary from state to state.
SOLUTION
The release valve is not closed.
✔
Turn the valve clockwise tightly.
Low on hydraulic fluid.
✔
✔
Refill the jack to the correct level of hydraulic
fluid.
Pump seals and back-up ring is defective.
✔
Clean oil passages, replace seals and renew oil.
(Must be serviced by qualified service center)
The hydraulic system is filled with air. Open
✔
✔
the release valve, pump handle rapidly (4)
full strokes to purge air, close release valve.
Return spring is broken or linkages binding.
✔
Replace spring if broken. Grease pivot shaft,
oil all lift arm linkages.
Discharge ball is not sealing hydraulic system
and oil may be dirty. Manually flush hydraulic
✔
system by raising and lowering lift arm by
hand. Open the release valve, as required to
raise and lower the lift arm. Manually raise
and lower lift arm.
PROBLEM
Jack will no
t lif
t load
Jack will no
t hold load
or handle rises
Jack will no
t lif
t t
o
its full heigh
t
Jack will no
t lo
we
r
co
mple
tely
Jack will no
t lif
t smoo
thly
or jack f
eels sp
ongy
