V1.3 | AU Support www.matchmaster.com.au | NZ Support www.matchmaster.co.nz |
Page 3 of 4
8. NAT
9. MANUAL RECORDING
10. PLAYBACK
NAT Access
After finishing the NAT settings, you can input
www.autonat.com in the IE address bar and then press
enter to go to the following interface. If you are the first
time to access the NAT, you shall download and install
the ActiveX according to the popup tips. After installing
ActiveX successfully, it will pop the login box.
Instant playback
Click “Instant Playback” in the right-click menu of
the camera’s preview window to select or drag the
playback progress bar to change the playback time to
play back the record.
General playback
Click play symbol on the tool bar at the bottom of the
live preview interface or click Start > Playback to go to
the playback interface as shown below. You can also
add the playback cameras manually. Click plus symbol
in the playback window to pop up the “Add Camera”
window. Check the cameras in the window and then
click “Add” to add playback camera. The record files
of the added playback camera will be played in the
playback interface.
Before recording, please install and format a HDD. In
the live interface you can see the menu toolbar. Click
movie symbol button to start recording. Click it again to
stop recording. You can also click movie with paper in
background symbol to check the status of
the recording.
Device Serial Number:
Click the monitor with paper in
background symbol on the menu bar at the bottom of
the live interface to check the serial number or go to
Start > Settings > Network > Network Status to check
the serial number of the NVR).
Username:
The username of the NVR. The default
username is admin.
Password:
The password of the NVR. The password is
set by yourself when you configure the wizard for the
first time.
1. The NVR shall be powered on and connected to the
network.
2. Go to Start > Settings > Network > TCP/IP. You can
obtain the IP address, subnet mask and gateway
automatically. You can also manually enter them
according to the actual network situation. Please
make sure the network segment is the same as that
of the network which is used.
3. Set the preferred or alternative DNS Server. Click
“Apply” to save the parameters.
4. Go to Start > Settings > Network > NAT tab. Enable
NAT and select the NAT Server Address (The default
NAT Server Address is nat.autonat.com). Click
“Apply” to save the parameters.
