Warning!
- Do not use the appliance as a fryer!
- Beware of inexpert handling!
Ignition
Turn on the main switch upstream of the appliance. Turn
the thermostat from ‘0’ to any temperature between 50°C
and 300°C. The pilot lamps will come on.
The green one shows that the appliance is on, while the
yellow one shows that the resistances are on.
As soon as the required temperature is reached, the yel-
low light will go off.
To turn the appliance off, simply turn the knob back to ‘0’.
.
042-03 - Electric tilting cooker
6
Before beginning installation, remove all packaging from
the appliance.
Some parts are protected with an adhesive film which
should be carefully removed.
Any remnants of glue should be thoroughly cleaned using
suitable substances such as benzine.
Under no circumstances should abrasive substances be
used. Fit the legs to the appliance; the appliance must be
levelled using a spirit level. Slight irregularities can be le-
velled by adjusting the feet themselves.
The main switch or plug should be located in the vicinity of
the appliance and easy of access.
We recommend installing the machine under a range
hood so that all the fumes are removed as quickly as pos-
sible. If the appliance is to be installed near walls, dividing
walls, kitchen equipment or decorative pannelling, these
should be in non-inflammable material or covered with
non-inflammable material.
Make sure that all fire prevention standards and safety pre-
cautions are strictly adhered to.
Legal and technical requisites
When installing the appliance, the following safety stan-
dards must be adhered to:
- Local accident prevention standards
- Current CEI standards.
Installation
Installation, start-up and maintenance should only be car-
ried out by expert personnel. All work required to install
the appliance should be carried out in compliance with all
local standards and regulations.
The manufacturers decline all responsibility where poor
performance is due to incorrect installation in disregard of
the above conditions.
Warning!
In compliance with international regulations, when
connecting the appliance to the mains power supply, a
device with a minimum aperture of 3 mm between con-
tacts must be fitted upstream of the appliance, al-
lowing omnipolar disconnection of the appliance from
the mains.
Wiring
When choosing the lead wire, make sure it has the fol-
lowing characteristics: it should be at least of the H07 RN-F
type and its section should be large enough for the ap-
pliance (see "Technical specifications and dimensions",
page 5). Cable entry is underneath the front left-hand
corner.
The terminal board is located behind the left-hand side of
the control panel on the front.
Pass the wire through the core hitch and wire clamp, plug
the leads into their terminals on the board and secure
them.
The earth lead must be a little longer than the others so
that it is the last lead to disconnect if the wire clamp
breaks.
Unipotential
The appliance must be connected up to a unipotential sy-
stem. The connection screw is located underneath the ap-
pliance on the right hand side. It is labelled.
Connection to waterworks
Water inlet pressure must be between 50 and 300 kPa,
otherwise install a pressure regulator on the line before the
appliance.
Install a cut-off valve for each supply on the line before the
appliance.
Make connections according to regulations currently in
force.
Warning!
The manufacturers cannot be held responsible for any
damage due to inadequate or incorrect installation.
Under such circumstances the guarantee will be consi-
dered null and void.
Start-up
Before starting the appliance up, check that it has been
properly installed.
Clean the pan with hot water and detergent, then turn the
thermostat to maximum and allow to dry. (see "Special
precautions", page 7).
INSTALLATION INSTRUCTIONS
USING THE APPLIANCE
