Page 10
ASSEMBLY
TO ADJUST THE FRONT-ASSIST
HANDLE POSITION
The handle should be adjusted so that your
front arm will be straight when using the
trimmer.
To adjust the front-assist handle position,
loosen the screw knob so that the front-
assist handle can be moved to the desired
position of the shaft. Tighten the screw knob
so that the handle cannot move on the shaft
during operation.
FIG. 5
TO ATTACH/REMOVE BATTERY
PACK (FIG 6)
FIG. 6
TO ATTACH BATTERY PACK
1. Make sure that the switch is in the OFF
position.
2. Align the raised portion on the battery
pack with the grooves on the bottom of
the tool, and then slide the battery pack
onto the tool as shown.
3. Ensure that the battery-release button
on the battery pack snaps into place
and the battery pack is secured to the
tool before beginning operation.
NOTICE:
When placing the battery
pack on the tool, be sure that the raised
rib on the battery pack aligns with the
groove on the tool and the latches snap
into place properly. Improper assembly
of the battery pack can cause damage to
internal components.
TO REMOVE BATTERY PACK
1. Make sure that the switch is in the OFF
position.
2. Press the battery-release button to
release the battery pack.
3. Pull rearward on the battery pack to
remove it from the tool.
WARNING:
Battery tools are
always in operating condition. Therefore,
the trigger switch should always be in the
OFF position when the tool is not in use or
when carrying the tool at your side.
Front-assist Handle
Battery-release
Button
Screw Knob
Bolt
