Masterflex ISMATEC 78018-50, Operating Manual, Page: 41 / 65

3-32 Masterflex REGLO Digital Pump Drive with Advanced Connectivity
Section 3: Operation
Masterflex
F. LOGOUT: Tap to log out a user. NOTE: This option is only available if Manage User is enabled in
Settings (for further information see " User Management " on page 3-9).
Analog Input
!
CAUTION
: Power must be turned off before connecting the external analog control cable to
prevent damage to the drive.
The REGLO supports and controls analog input using suitable equipment through the pump drive’s DB-25
female connection port. Analog input can be used in place of, or in addition to, MasterflexLive™.
See also " DB-25 Electrical Connections " on page 3-44.
General Preparation:
• Confirm the correct transfer tubing is securely attached to the pump head.
• Confirm all fluids and containers are ready.
• Switch the drive on using the power switch located at the rear of the drive.
NOTE:
If Manage User
is enabled you may be prompted for a Username and Password (for further information see " User
Management " on page 3-9). The touchscreen display will revert to the previously used operation mode.
• Confirm that the pump head has been calibrated (for further information see " Pump Head Calibration " on
page 3-12).
• If required, prime the pump before operation (for further information see " Priming the Pump " on page
3-11).
• Confirm that the pump drive is connected to the appropriate equipment through the drive’s DB-25
female connection port (for further information see " DB-25 Electrical Connections " on page 3-44).
To operate analog input control and monitoring:
1. Tap ANALOG INPUT from the Mode Selection Screen. The Analog Input Mode Run Screen will be
displayed.
2. Tap EDIT . The Analog Input Mode Edit Screen will be displayed.
3. Tap the desired analog input type from the available list.
4. If using either ANALOG: VOLTAGE or ANALOG: CURRENT:
a. Select the desired current or voltage operating range from the available list.
b. Tap CONFIRM to save or CANCEL to cancel and return to the previous screen.
NOTE:
• Tap STOP on the pump drive touchscreen to override the remote control device and immediately stop
the pump operation. NOTE: If locked, the screen will need to be unlocked before the pump operation
can be stopped.
• See www.masterflex.com for further information on using analog input remote control and monitoring.