DO NOT attempt to operate this machine if it is not fully assembled.
When servicing or replacing an accessories turn OFF the machine
and disconnect from power source.
To start operating, tilt machine back on transport wheels, turn ON
machine and carefully lower machine onto the working surface.
1)
Clear the floor of any materials or objects.
2)
Select and install the accessory set
required for the job. (See above for installa-
tion instructions.)
3)
Move handle from the upright “storage”
position to the angled “operating” position
and lock in place with the quick release pin.
4)
Place your hands on the handle grips tilt
sander back on the transport wheels.
5)
Engage the safety trigger and trigger lock
beneath the right handle grip.
6)
When the machine is running, carefully
lower it onto the working surface and
release the trigger lock.
7)
To stop the machine release the safety
trigger and it will automatically turn
OFF
.
8)
Move the machine side-to-side while
maintaining a steady, consistent pace with
the machine.
9)
When not in use a set of attachments
MUST
be left on the sander to protect the
heads.
Note:
If the machine unexpectedly shuts
down due to a circuit overload, before
restarting the wait 30 seconds, then press
the reset button .
When installing or changing the accessories, turn OFF the sander
and disconnect the power cord from the electrical outlet.
Before Installation or Changing of
Attachments:
1)
Unplug the sander from the wall outlet.
2)
Ensure handle is in the storage position
(straight up) and locked in place with the
quick release pin.
3)
Tilt machine back by bracing it with your
foot until the handle is laying on the floor and
the three heads are fully exposed.
N
No
otte
e:: It is recommended that a towel or pad is
placed under the machine to protect the floor.
Changing and Installation the
Attachments
1)
Position the first attachment head at 12
o’clock.
2)
Using both hands, reach beneath the bot-
tom side of the attachment and pull up
towards yourself to free it from the sander.
3)
Select the attachment required for the
job, and line up the holes on the attachment
with the four metal pins protruding from
each of the three heads.
4)
Push the attachments on by hand and if
necessary, carefully tap it into place with a
rubber mallet.
5)
Repeat steps 1 thru 4 with the remaining
2 attachments.
6)
Carefully raise the handle, supporting the
axle with your foot to control the head of the
machine as it is placed on the floor.
7)
Since the attachments are different
heights you may need to adjust the dust
skirt to make sure it is level with the attach-
ments. This will ensure clean and virtually
dust-free operation.
9)
To adjust skirt, align the skirt with the cen-
ter of the machine and wrap it around.
10)
Move the handle back to the operating
position and lock in place with the quick
release pin.
When installing or removing attachments, always wear protective gloves and start at the
12 o’clock position.
A
TTACHMENTS
I
NSTALLATION
& C
HANGING
C
AUTION
:
P
AGE
3
C
AUTION
:
F
LOOR
M
ACHINE
O
PERATION
I
NSTRUCTIONS
