The 1500 RPM burnisher should
only be used for high luster burnish-
ing or polishing. It can be used in
conjunction with any of the ultra high
speed chemical systems. It is
mandatory, however, that the floor
be prepared as directed by the
chemical manufacturer. This will
eliminate a possibility of damage to
floor due to the high speed of the
burnisher.
C
ARBON
B
RUSH
W
EAR
W
ARNING
L
IGHT
This burnisher is equipped with a carbon
brush wear indicator warning light,
located in the motor canopy facing the
operator. The instructions on the top
surface of the motor canopy read as fol-
lows:
When the lamp is lit, the Motor Carbon
Brushes must be replaced within 20
hours of service to prevent damage to
the motor.
Carbon Brushes Part Nos:
Imperial Motor
: Part No 386790 (4)
Ohio Motor*
: Part No 380083 (3)
& 316954 (1)
*
Burnishers with Ohio Motors have "X" after
the serial number.
Note:
After replacing the second set of car-
bon brushes, the commutator of the arma-
ture may need to be undercut and the mica
slotted. This should be done by an experi-
enced motor repair shop.
Part No 344273 Rev D- Printed in USA 05/12/06
1500 RPM
B
URNISHER
O
PERATING
I
NSTRUCTIONS
This unit is intended for commercial use.
P
AGE
1
Begin operating this burnisher at the
closest point to your electrical outlet,
working away from the outlet. This will
prevent running over the electric cord.
Operate the burnisher in a straight-line
path and avoid continuous operation in
one spot.
DO NOT
hold burnisher stationary while
it is running, this will result in damage to
floor and floor finish.
If burnisher wobbles, vibrates or
pulls, follow these instructions:
1)
This burnisher is factory adjusted
and set to operate between 13.2 and
14 amps.
2)
Never leave burnisher resting on floor
pad overnight. This will cause the pad to
lose its normal shape, causing wobbling
and vibration. Check pad for unevenness
and change is necessary.
3)
Before turning burnisher on, run tip
of finger between outside of pad and
floor. The outer ring face should be in
full contact with the floor in order for
high speed buffing to be most effective.
If necessary change pad.
4)
If steps 2 and 3 do not correct the
problem, a certified technician should
reset rear wheels, of the burnisher as
follows:
Adjusting knobs operate individually. To
raise or lower the rear portion of the
large wheels, untighten set screw on
the under side of each knob using a
5/32 allen wrench. The body is raised
when knob is turned to the right and
lowered when knob is turned to the left.
If the Burnisher Has:
Forward Pull:
Raise left side only
Backward Push:
Raise right side only
Right Pull:
Lower Both sides equally
Left Pull:
Raise both sides equally
After adjustments have been made the
technician must check the amp draw
keeping it within the 13.2 - 14 amp,
factory specifications. Failure to do so
may cause the unit to draw excessive
current and damage the burnisher.
Retighten both set screws.
O
PERATION
I
NSTRUCTIONS
