MasterCraft Aviara AV32, Owner'S Manual

Page: 170 / 285

2.
Press
and hold SWIM PLATFORM MASTER POWER button
on switch panel for 1.3 seconds. The keypad will make a single
audible beep, then beep twice after 1.3 seconds. Additionally an
indicator light will illuminate. This indicates that power is going
to the swim platform and that it can be operated. After activating
the master power, the platform will be operable for 10 minutes. If
while pressing the SWIM PLATFORM MASTER POWER button the
keypad rapidly beeps and light rapidly flashes, one of the conditions
from step one (1) have not been met and no operation will occur.
3.
To deploy the platform, press the PLATFORM DOWN button
until the platform is fully deployed. To raise the platform,
press the PLATFORM UP button until platform is fully raised
and locked. At any point, removing your finger from the
keypad button will stop the platform where it is.
4.
Additionally, should the SWIM PLATFORM MASTER
POWER switch fail for some reason, the platform may be
raised using the SWIM PLATFORM OVERRIDE RAISE
switch mounted adjacent to the battery switches in the rear
sunpad storage hatch (see image below).
NOTE: If SWIM PLATFORM MASTER POWER button’s indicator light is
on, the buttons for raising or lowering the platform are active and will
remain so for 10 minutes or until you press and hold the master power
button again, or any of the above 3 conditions are no longer met.
NOTE: Due to safety, when the swim platform is deployed, the
engines will be disabled. There is an override switch however
should the swim platform have a failure and it is necessary to get
back to shore. See Override Operations in the following section if
starting engines is required without retracting the swim platform.
Platform, terrace and or engine damage may occur if not fully
retracted and locked.