14
INSTALL EDGE GUIDE MOUNT
– cont’d
4. Tighten the mounting screw using a
5 mm hex key.
NOTE:
Do not over tighten the
mounting screw. You will break the
blade guard.
INSTALL EDGE GUIDE
The multi-cutter can be used with an edge
guide for ripping materials up to 6” wide.
1. Turn two edge guide locking screws
(1) counter clockwise a few turns until
the screws rise about 1/8”
(see Fig. 7b).
2. Insert edge guard rod (2) into the edge
guide mounting block slot (3).
3. Slide edge guard toward the tool until
the desired width of cut is indicated on
the scale (4) where it meets the edge
of the edge guide mounting block.
4. Tighten both edge guide locking
screws.
NOTES:
a) Do not over tighten the edge guide
locking screws or you will break the
edge guide mounting block.
b) The edge guide scale is only an
approximate measurement. Always
check the width of cut on a scrap
workpiece.
Fig. 7b
ASSEMBLY AND OPERATION
– MULTI-CUTTER
Have you read “POWER TOOL
SAFETY”, “SPECIFIC SAFETY
RULES”, EXTENSION CORD
SAFETY” and “SYMBOLS” on pages
3, 4, 5, 6 & 7 of this Manual? If not,
please do it now before you operate
this multi-cutter. Your safety
depends on it!
Every time you use the multi-cutter
you should verify the following:
1. Correct blade is installed for the
material being cut.
2. Blade is in good condition and
properly installed.
3. Blade guard is in place and in
good working order.
4. Workpiece is properly secured.
5. Safety glasses are being worn.
Failure to adhere to these safety
rules can greatly increase the
chances of injury.
WARNING
!
Fig. 7a
Summary of Contents for 54-8333-2
Page 10: ...10 TOTE CONTENTS ...
