This floor machine is designed for many
different floor cleaning applications. It is
important to select the correct brush or
floor pad depending upon the type of
cleaning operation you are doing.
When using floor pads, to achieve the
best results use clean pads and change
them as they load up.
Brush/Pad Installation:
1)
Unplug the power cable and
LOCK
the handle in the upright position.
2)
Tilt the machine back until the handle
is laying on the floor and underside of
the machine is fully exposed.
3)
Holding the pad driver/brush in both
hands, straddling the motor with your
back to the handle, bend over and fit the
three slots of the clutch plate over the
three lugs of the drive plate.
4)
Turn the brush counterclockwise as
far as it will go. It is now seated and
ready for operation
Note:
The brush/pad surface should be
flat and level on the floor.
Brush/Pad Removal:
Disengage clutch plate slots from drive
plate lugs by turning clockwise.
O
PERATING
I
NSTRUCTIONS
Never turn this floor machine ON with handle locked in the upright position.
DO NOT leave a plugged in floor machine unattended.
Always unplug the machine before leaving to prevent accidental startup.
Always install the brush/pad driver by hand.
“NEVER”
lay brush/pad driver on the floor, position the machine
over it, and turn the machine ON to lock brush/pad driver in place.
This is called
JUMPING
the brush and is dangerous.
P
AGE
3
C
AUTION
:
C
AUTION
:
B
RUSH
/P
AD
D
RIVER
I
NSTALLATION
C
AUTION
:
This floor machine is designed to move
from side to side. Begin operating at the
closest possible point to an electrical out-
let and work away from the outlet. This
will prevent running over the electrical
cord.
Note:
Before installing the brush/pad
driver, plug in the machine and make
sure the motor is only running when the
triggers are activate and not before.
Setup for operation:
1)
Install pad driver/brush
(see instruc-
tions above)
and plug in power cable.
2)
Adjust the handle by pulling up on the
clamping lever located at the rear of the
machine.
3)
Pull the handle toward you until you
reach a comfortable operating position.
4)
Step down firmly on the clamping
lever and lock handle place.
Note:
When transporting the machine
or attaching pad driver/brush, handle
must be
LOCKED
in the upright position.
5)
Place your hands on the handle grips
and squeeze trigger locks beneath grips
to activate the motor and start the
brush operating.
To begin operating:
1)
To move unit right, slowly apply slight
upward pressure. As the handle is
raised higher, the faster it will move to
the right.
2)
To move unit left, slowly apply slight
pressure downward. As the handle is
lower, the faster it will move to the left
3)
To move unit forward or backward,
keep brush/pad surface flat on the floor
and push or pull machine in the direction
required.
4)
To stop the floor machine, release
triggers.
Machine wobbles or vibrates:
1)
Adjust by turning the pad or brush
1
/
3
turn, then reinstall on machine.
2)
Inspect the brush/pad driver for
warpage or out of round. Lay floor
machine down on handle with
brush/pad driver in place. With
machine running, observe if brush/pad
driver appears to wobble or is out of
round. Replace if this problem occurs.