11
11
13
17
24
Fig P
Fig Q
Fig R
Note: Pull out the ball
bearing track completely
before you attach drawer.
The oval hole at the front of the slider allows for the gaps
between the drawers to be adjusted. Make the adjustments
once all the drawers are installed.
A: Pull out the sliders completely, then attach the
drawer to the sliders. Make sure the square holes
on the drawer side panels are lined up, and the
drawer is hooked onto the sliders completely
(see Fig P and Fig Q).
B: Use 4 pcs Screw (17) to tighten the drawer,
and put the Drawer Mat (24) into the drawer
(see Fig R).
Repeat above steps to place other drawers.
Note: Do not tighten any screws completely
until all the drawers are adjusted well.
Step 14: Place the Drawers.
