13
12
This Mastercraft
®
Air-powered Coil Framing Nailer drives 2 to 3 1/4” wire weld collated
full-head nails.
WARNING!
WARNING!
It is recommended that a filter-regulator-lubricator be used and be located as close to the tool
as possible.
If a filter-regulator-lubricator is not installed, place up to 6 drops of compressor oil into the air
inlet plug before each use.
If a filter-regulator-lubricator is installed, keep the air filter clean. A dirty filter will reduce the
air pressure to the tool, which will cause a reduction in power, efficiency, and general
performance.
For optimal performance, install a quick connector to the tool and a quick coupler on the
hose, if applicable.
Verify that all of the connections in the air supply system are sealed in order to prevent air
leakage.
Read this Instruction Manual carefully before using the air-powered nailer.
• Read and follow all the safety instructions at the beginning of this manual. Inspect the
air-powered nailer prior to each use in order to:
– ensure that the proper power source is being used.
– verify that the tool is in proper working order.
•
•
•
•
•
Potential hazard that could result in serious injury or death.
• Do not use the tool if it is not in proper working order.
• Do not use oxygen or any other combustible or bottled gas to
power this tool.
• Do not use this tool in the presence of any flammable liquids or
gases.
• Keep hands and other parts of the body away from the firing
head during use.
• Do not point the tool towards the operator or other people.
• Do not attempt to clear a jammed nail when the air hose is
connected.
• Do not drive a nail on top of an existing nail. Failure to comply
could lead to serious injury or loss of life.
Note
: Icons are colour coded. Please refer to the actual tool for the
specific colour.
Potential hazard that could result in serious injury or death.
• The use of any other types of nails will cause the nailer to
jam and could lead to serious injury or death.
TECHNICAL INFORMATION
TYPES OF NAILS
model no. 058-9809-8 | contact us 1-800-689-9928
ACCEPTABLE NAILS
Length: 2 x 0.099" – 3 1/4 x 0.131" (50 to 83 mm) Angle: 15°
NAIL TYPE ICONS
These icons are used to select the proper nails for this specific nailer.
model no. 058-9847-6 | contact us 1-800-689-9928
15
WIRE-WELD-COLLATED
FULL-HEAD NAILS
.099"
(2.5 mm)
2"
(5
0
m
m
)
.236"
(6 mm)
.131"
(3.3 mm)
3
1/
4"
(8
3
m
m
)
.283"
(7.2 mm)