MasterCraft 058-8489-4, Instruction Manual

Page: 18 / 30

OPERA
TING INSTR
UCTIONS
18
AIR
-
POWERED 3
-
IN
-
1 NAILER 058
-
8489
-
4
Firing modes
The Mastercraft
®
Air
-
powered 3
-
in
-
1 Nailer is equipped with a single sequential actuation mode that
follows the steps below:
• Press the safety stand (1) against the
workpiece
(fig H)
.
• Pull the trigger (2) to drive the fastener
(fig H)
.
• Lift the safety stand off the workpiece
and prepare to fire the next fastener.
• If the stand remains pressed against
the workpiece, successive fasteners
will be fired each time the trigger is
pulled.
Fastener depth adjustment
The Mastercraft
®
Air
-
powered 3
-
in
-
1 Nailer
has a depth adjustment dial below the trigger
to adjust the firing depth of fasteners
(fig I)
.
Note: Refer to the graphic imprinted below
the trigger and adjust the firing depth
accordingly.
CAUTION!
Potential hazard that may result in moderate injury or damage to
equipment.
• Operate the tool with the utmost care when connected with air compressor
.
Failure to comply may result in moderate injury or damage to equipment.
MC-588489-12
fig H
2
1
MC-588489-09
fig I