MasterCraft 058-8122-6, Instruction Manual, Page: 13 / 29

IMPOR
TANT INFORMA
TION
13
AIR
-
POWERED PIN NAILER 058
-
8122
-6
• It is recommended that a filter
-
regulator
-
lubricator be used and be located as close to the tool
as possible.
• If a filter
-
regulator
-
lubricator is not installed, place up to 6 drops of compressor oil into the air
inlet plug before each use.
• If a filter
-
regulator
-
lubricator is installed, keep the air filter clean. A dirty filter will reduce the
air pressure to the tool, which will cause a reduction in power, efficiency, and general
performance.
• For optimal performance, install a quick connector to the tool and a quick coupler on the
hose, if applicable.
• Verify that all of the connections in the air supply system are sealed in order to prevent air
leakage.
Read this Instruction Manual carefully before using the Air
-
powered Pin Nailer.
• Read and follow all the safety instructions at the beginning of this manual. Inspect the
Air
-
powered Pin Nailer prior to each use in order to:
– ensure that the proper power source is being used.
– verify that the tool is in proper working order.
WARNING!
Potential hazard that could result in serious injury or loss of life.
• Do not use the tool if it is not in proper working order.
• Do not use oxygen or any other combustible or bottled gas to power this tool.
• Do not use this tool in the presence of any flammable liquids or gases.
• Keep hands and other parts of the body away from the firing head during use.
• Do not point the tool towards the operator or other people.
• Do not attempt to clear a jammed nail when the air hose is connected.
•
Do not drive a nail on top of an existing nail. Failure to comply could lead to
serious injury or loss of life.