3
4
2-GALLON (7.6 L) AIR COMPRESSOR- 058-7000-2
2-GALLON (7.6 L) AIR COMPRESSOR - 058-7000-2
TEC
HN
IC
AL
S
PEC
IF
IC
ATI
ON
S
PRODUCT NUMBER
058-7000-2
PEAK HORSEPOWER
1/3
TANK SIZE
2 U.S. GALLONS
(7.6 L)
AIR DELIVERY (SCFM*) @ 40 PSI 1.0
AIR DELIVERY (SCFM*) @ 90 PSI 0.7
CUT-IN PRESSURE (PSI)
85
CUT-OUT PRESSURE (PSI)
100
FUSE
3 A, 5 x 20 mm
POWER
120 V, 60 Hz, 2.6 A
WEIGHT
16 lb
(7.3 kg)
POWER CORD
STJ 18 AWG / 6'
(1.82 m)
EXTENSION CORD
SJT 16 AWG / MAXIMUM 50’
(15 m)
* SCFM:
Standard Cubic Feet per Minute
(=
The volumetric flow rate of a gas
corrected to standardized conditions of temperature and pressure.)
This manual contains information that relates to
PROTECTING
PERSONAL SAFETY
and
PREVENTING EQUIPMENT PROBLEMS
. It
is very important to read this manual carefully and understand
it thoroughly before using the product. The symbols listed
below are used to indicate this information.
DANGER!
Potential hazard that will result in serious injury or loss of life.
WARNING!
Potential hazard that could result in serious injury or loss of life.
CAUTION!
Potential hazard that may result in moderate injury or damage to equipment.
IMPORTANT!
Installation, operation or maintenance information that is important but
not hazard related.
Safety Advice
DANGER!
1.
RISK OF FIRE OR EXPLOSION.
Do not spray a flammable or combustible liquid or
paint near sparks, flames, pilot lights or in a confined area. The spray area must be
well-ventilated. Keep compressor at least 20’ (6 m) away from spray area. Do not
carry and operate the compressor or any other electrical device near the spray area. Never smoke
when spraying. Use a minimum of 25’ (7.6 m) of hose to connect a spray gun to the compressor.
2.
RISK OF ELECTRIC SHOCK.
Do not expose to rain. Store indoors. Hazardous voltage.
Disconnect from power source before servicing. Compressor must be grounded. Do
not use grounding adaptors.
3.
RISK OF BURSTING.
Make sure the regulator is adjusted so that the compressor outlet
pressure is set lower than the maximum operating pressure of the spray gun or tool.
Before starting the compressor, pull the ring on the safety valve to make sure the valve
moves freely (see diagram on page 18). Drain water from tank after each use. Do not
weld or repair tank.
SA
FE
TY
G
UI
DEL
IN
ES
058-7000-2-Air-Compressor-2G-EN-03.indd 3-4
6/11/12 8:14 AM
