2
Fig. 2
Setting the depth control
NOTE:
Operating the engraving tool
WARNING:
NOTE:
WARNING:
The engraver will build up heat
during continuous operation. Do not operate the engraver
continuously for more than 5 minutes at a time. After 5
minutes of continuous operation, the tool must be turned
OFF and allowed to cool down for at least 5 minutes.
!
Fig. 2
Fig. 3
!
Fig. 4
three years from the date of original retail purchase
These warranties are subject to the following conditions and limitations:
i.
Additional Limitations
.
Notice to Consumer
TOLL-FREE HELPLINE: 1-800-689-9928
