OPERA
TING INSTR
UCTIONS
10
SHOP HEATER 043-6079-6
Operation
1.
Place the heater in the coolest part of the room. Plug the heater directly into 120 V AC, 60 Hz
wall outlet.
2.
Turn the power control dial from the OFF position to the LOW or HIGH setting and rotate the
thermostat control knob in clockwise to the HIGH THERMOSTAT position to turn ON the heater.
Note: During the initial use of the heater, you may notice a slight odour or smoking as the result of
the heating element lubrication “burning off”. This condition is normal. After few minutes, the both
smell and smoke will leave off.
3. After the heater has been turned ON and the room has reached the desired temperature,
slowly rotate the thermostat control knob counter
-
clockwise until a “click” sound is heard and
the heater shuts off. With the thermostat control knob in this position, the temperature will be
maintained automatically.
4. To lower the temperature, rotate the knob counter
-
clockwise towards the LOW position. To
raise the temperature, rotate the thermostat control knob clockwise towards the HIGH position.
5. Turn the power control dial to the fan setting and turn the thermostat control knob fully in a
clockwise direction to operate the fan continuously.
6. Turn the power control dial to the OFF position before unplugging or plugging in the heater.
CAUTION!
Potential hazard that may result in moderate injury or damage to
equipment.
•
Always operate the heater in an upright position. Failure to comply may result
in moderate injury or damage to equipment.
WARNING!
Potential hazard that could result in serious injury or loss of life.
•
Do not plug the heater into a circuit that is servicing other electrical needs to
prevent overloading of the circuit.
•
Always ensure that the plug fits into the outlet tightly. A loose connection may
cause overheating and damage to the plug or heater.
•
Unplug the heater when not in use.