EN
36
NOTE !
Before proceeding with the troubleshooting, di
-
sconnect the cooker from the power supply to
avoid being electrocuted.
In the warranty period all repairs except for the
•
ones specified below should be carried out by the
authorised Servicing Point.
If there are some disturbances during the use of
•
the appliance, follow the guidelines below to check
if you can repair the defect yourself.
Problem
Solution
Igniters fail to ignite or not always ignite
the gas
Check to make sure the cooker is connected to the electrical mains.
–
Clean and dry the igniters and burner components.
–
Check to make sure the burner caps and heads are placed correctly.
–
Press on the burner cap and rub it against the head by turning right
–
and left (fig. 12.1.1).
Rub the igniter electrode with the use of hard brush or smooth file (fig.
–
12.1.2).
Gas burners fail to ignite
Check to make sure the rubber hose supplying gas from the gas cylin
-
–
der is not squeezed.
Check to make sure the gas main valve is open.
–
Check to make sure the gas cylinder is not empty.
–
In case a new cooker has been installed or the gas cylinder has been
–
replaced with a new one, then it is necessary to repeat the ignition
procedure until the gas reaches the burner.
Check to make sure the nozzle or burner flame holes are not clogged
–
or flooded. If so, un-clog the nozzle hole using a pin or needle. Clean
the burner flame holes with the use of brush, and then dry all compo
-
nents.
Flame dies after releasing the knob
Your cooker is equipped with a flame failure safety device
Where the ignition device is built in the knob set the
–
knob to large fla
-
me , press the knob and when the gas has ignited keep it pressed
all the way in
for another few seconds. .
While igniting one of the burners all the
hob burner igniters spark
It is normal
When pressing the selected knob (with a built-in ignition device) or the
ignition button sparks are re-leased at all the burners .
After setting the knob to simmering flame
position - the flame dies or is too high
Avoid draughts in the kitchen,
–
Call the fitter to adjust simmering flame position
–
.
Flame is unstable
Check to make sure that the burner components are clean, dry and
–
placed correctly.
12.1.1 12.1.2
Summary of Contents for KG-1319ZB PLUS
Page 2: ...1 ...
Page 39: ...EN 38 ...
