WARNING:
Connecting and removing the battery 12 V car plug-in power base
1. Unravel cord before use . If battery is installed, remove from the machine by pressing battery
release button and pulling out
2. Slide the 12V DC Car Adapter pack into the machine until you hear a click.
3. Connect the adapter into the DC socket in your car When ready to use, power car on. Always
operate vehicle outdoors.
NOTE: Be sure the cord runs through the hole at the base of the pack.
AIR HOSE AND ACCESSORY STORAGE
When the inflator is not in use, press the hose into the storage area on top of the tool.
When not in use, adaptors and needles provided with the inflator can be placed in the storage area of
the tool.
LED WORKING LIGHT
When working, the LED light on the base of the tool is on, which is good for nightwork.
START SWTICH AND SELF-LOCKING SWTICH(See Figure.5)
1. When press start switch, push self-locking switch up, which will make the switch in LOCK-ON.This
guarantees the safety for the user and of the tool.
2. After the pressure enough, pressing the start switch, then the self-locking switch will sprang back
down.
USING THE INFLATOR
1. Install the battery pack.
2. Position air chuck clamp in the unlock position perpen- dicular to the air hose.
3. Place the air chuck on the valve stem.
4. Push the air chuck down so that the threaded section of the valve stem is inside the air chuck.
Clamp the end of the air chuck down onto the valve stem by pressing air chuck clamp down until it
stops or is parallel with the air hose.
Improperly attached hoses or accessories can become detached under pressure
and causeserious injury. Possible air leaks can cause faulty pressure readings.
Make sure all connections are tightly secured.
5. If self-locking swtich is up, turn it down .
6. Press “ON/Unit” button to read the current tire pressure on the gauge. Press “ON/Unit” button
again to select tire pressure measurement unit from PSI, KPA, BAR, KG/CM.
7. Press “+” or “-” button to adjust preset tire pressure.
(1) Long press “+” or “-” button to adjust working pressure quickly.
(2) Press “+” or “-” button each time can adjust preset working pressure by 0.05BAR &KG/CM, 0.5
PSI, 5KPA.
8. Preset pressure value will be set after flashing for 3 seconds.
Press switch to start inflating. When it reaches the preset pressure value, the device will stop
working.
NOTE:
To reset the tire pressure measurement unit, press "ON/Unit" to reselect after setting
preset pressure value.
NOTE:
Digital gauge records the preset measurement unit and value of last time operation
NOTE:
After the air pump reaches the preset pressure value, the digital gauge will go off after
30 seconds, and the device will shut down automatically.
NOTE:
Maximum PSI for this unit is 100PSI.
!
OPERATION
8
Fig.5
Summary of Contents for MW110D
Page 11: ......
